100 톤 극히 순수한 역침투장비를 특화하세요

High-Quality Plant Customize Reverse Osmosis Equipment 0.5-100 Ton Large Ultrapure Water Equipment

Main process flow

multi-media filter - softener - security filter - reverse osmosis - ultraviolet - ozone disinfection

1. Raw water tank (optional)
Storage of raw water, used to precipitate large sediment particles and other sedimentable substances in the water. At the same time, the impact of unstable water pressure in the raw water pipe on the water treatment system is buffered. (Such as the pressure sensor response caused by too low or too high water pressure).

2. Raw water pump
Constant system water supply pressure, stable water supply.

3. Multi-media filter
The filter with multiple filter layers is mainly used to remove the material with particles above 20um, such as silt, rust, colloidal matter, suspended matter, etc. contained in the raw water. Manual valve control or fully automatic controller can be used for backwashing and normalizing. A series of operations such as flushing. Ensure the water quality of the equipment and prolong the service life of the equipment.

4. Activated carbon filter
The system uses a nutshell activated carbon filter. The activated carbon can not only adsorb electrolyte ions, but also perform ion exchange adsorption. The activated carbon adsorption can also reduce the oxygen consumption (COD) of potassium permanganate from 15mg/L(O2) to 2～7mg/L(O2). In addition, the concentration of adsorbed replication on the surface increases due to the adsorption effect. It plays a catalytic role, removes pigments, peculiar smells, a large amount of biochemical organic matter in water, reduces the residual chlorine value of water and pesticide pollutants, and removes trihalides (THM) and other pollutants in water. A series of operations such as backwashing and positive washing can be performed with manual valve control or fully automatic controller. Ensure the water quality of the equipment and prolong the service life of the equipment. At the same time, the equipment has a self-maintenance system, and the operating cost is very low.

5. Ion softening system/dosing system
The R/O device is for the concentrated discharge of dissolved solids and the utilization of fresh water, and to prevent CaCO3, MgCO3, MgSO4, CaSO4, BaSO4, SrSO4, SiSO4 from appearing on the concentrated water side, especially the concentrated water side of the last membrane module of the reverse osmosis equipment. The concentration product is greater than its equilibrium solubility constant and crystallizes out, which damages the original characteristics of the membrane. Before entering the reverse osmosis membrane module, an ion softening device or an appropriate amount of scale inhibitor should be used to prevent the crystals of carbonate, SiO2, and sulfate. Precipitate.

6. Precision filter
A precision filter is used to remove residual suspended solids, non-curved particles, colloids and other substances in the incoming water, making the RO system and other subsequent equipment operations safer and more reliable. The filter element is a 5um melt blown filter element, the purpose is to remove the impurities larger than 5um leaked by the upper filter unit. Prevent it from entering the reverse osmosis equipment to damage the surface of the membrane, thereby damaging the desalination performance of the membrane.

7. Reverse osmosis system
The reverse osmosis equipment uses enough pressure to separate the solvent (usually water) in the solution through the reverse osmosis membrane (or semi-permeable membrane). Because this process is opposite to the direction of natural osmosis, it is called reverse osmosis. The reverse osmosis method can adapt to all kinds of raw water with salt content, especially in the water treatment project with high salt content, it can obtain good technical and economic benefits. The reverse osmosis method has improved desalination rate, high recovery rate, stable operation, small footprint, and simple operation. While the reverse osmosis equipment removes salt, it also removes most of the bacteria, colloids and large molecular weight organic matter.

8. Ozone sterilizer/ultraviolet sterilizer (optional)
Kill the bacteria produced by secondary pollution and completely ensure the sanitary indicators of the finished water.